 |
|
This series began as an exploration of a Mobius ribbon on a circular and elliptical path; a half turn, 180 degrees,
and full turn 360 degrees evolving to four full turns and then replacing the ribbon with two rods, the edges of the ribbon itself.
Since the two rods never touch, the twists end up floating free, requiring another rod to hold them together to make a bangle.
3D printed in bendable Nylon Plastic
Available in a polished finish in these colors: White, Black, Pink, Red, Orange, Yellow, Green, Blue, Purple
and
3D printed in Steel
Stainless Steel, Matte Gold Steel, Polished Bronze Steel
Size: Large, 2 5/8” (67 mm) inside diameter,
Medium, 2 1/2” (64 mm) inside diameter,
Twist portion is approximately 1/2” (13 mm) high and 1/2” (13 mm) wide
Overall size:
In:3.566 w x 3.566 d x 0.465 h
Cm: 9.054 w x 9.054 d x 1.18 h
 |
 |
Twisty Twist Bangles A Series |
 |
Twisty Twist Bangle A01 This bangle is constructed by two twisting rods covering four revolutions of 360 degrees each, they are only held together by a single circular rod on the inside of the bangle. |
 |
Twisty Twist Bangle A02 This bangle is constructed by two twisting rods covering four revolutions of 360 degrees each, they are only held together by two circular rods, one on the inside, and one on the outside of the bangle. |
 |
Twisty Twist Bangle A03 This bangle is constructed by two twisting rods covering four revolutions of 360 degrees each, they are only held together by two circular rods, one on the top, and one on the bottom of the bangle. |
 |
Twisty Twist Bangle A08 This bangle is constructed by two twisting rods covering four revolutions of 360 degrees each,one is offset from the other, then they are wrapped with two other rods, one on the inside, and one on the outside. |
 |
Twisty Twist Bangles C Series |
 |
Twisty Twist Bangle C01 This bangle is constructed by two twisting rods covering four revolutions of 360 degrees each, they are only held together by a single circular rod on the inside of the bangle. |
 |
Twisty Twist Bangle C02 This bangle is constructed by three twisting rods covering four revolutions of 360 degrees each, they are only held together by a single circular rod on the inside of the bangle. |
 |
Twisty Twist Bangle C04 This bangle is constructed by two sets of two offset twisting rods covering four revolutions of 360 degrees each. |
 |
Twisty Twist Bangle C05 This bangle is constructed by four twisting rods covering four revolutions of 360 degrees each,one is offset from the other, they are only held together by a single circular rod on the inside of the bangle. |
 |
Wavy Wave Bangles B Series |
 |
Wavy Wave Bangle B02 This bangle is constructed by two and four twisting rods covering four revolutions of 360 degrees each, one is offset from the other. |
 |
Wavy Wave Bangle B04 This bangle is constructed by two sets of two twisting rods covering four revolutions of 360 degrees each, one is offset from the other. |
 |
Wavy Wave Bangle B21 This bangle is constructed by two, two, and four twisting rods covering four revolutions of 360 degrees each, one is offset from the other. |
 |
Wavy Wave Bangle B25 This bangle is constructed by two and four twisting rods covering four revolutions of 360 degrees each, one is offset from the other. |